Ripmax Husky C-RMX0020 - UK Instrucciones de operaciones descargar pdf (Pagina 9)

Page 9

❑ Slide the receiver antenna wire into one end of the antenna support tube and

out the other end.

❑ 

gently tighten the nut to lock the antenna support tube

into place.

IMPORTANT

you cut the antenna wire shorter.

PRO TIP



cleaner will make the antenna wire slide through the support tube much easier.

❑ Slide the transmitter's ON/OFF switch up to turn the transmitter on. The green

LED should glow brightly. On some transmitters both the green and the red LEDs

will glow brightly.

IMPORTANT If the green LED does not glow or if only the red LED is glowing,







❑ Slide the receiver's ON/OFF switch to turn the receiver on. You should hear the

servos move to their proper positions.





This will prevent the possibility of a runaway model or damage to the servos.

SAFETY TIP

STEP 2: RANGE CHECKING THE RADIO CONTROL SYSTEM

To ensure that the radio control system is operating properly and to prevent any chance of a runaway model, the radio control system



❑ With the transmitter and receiver turned on, extend the transmitter antenna completely.

❑ 

while looking at the XT2's wheels. The wheels should pivot back and forth as you rotate the steering wheel back and forth.

IMPORTANT

further. Never attempt to operate your X-Terminator 2 RTR Nitro Buggy if the radio control system is not functioning properly.

WARNING Never attempt to recharge Alkaline batteries. Doing so could cause them to explode.

❑ Remove the four screws from the receiver mounting box cover, then remove the

receiver mounting box cover.

❑ 

then reinstall the receiver mounting box cover, making sure not to pinch any of the

servo wires.

IMPORTANT Verify that the steering and throttle servo leads are plugged into

channel 1 and channel 2, respectively.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Sin comentarios

Ripmax Husky C-RMX0020 - UK Instrucciones de operaciones Pagina 9